Plessey PRC 320/1 - Page 54

The procedure for fitting and operating the generator
is as follows:-
42
2.22.1 Lift the battery retaining latches on
the RT320/1, fit the generator so that its
Spring contacts engage with the contact studs
of the RT220/1 and then close the retaining
latches.
2.22.2 Lift the battery retaining latches on
the generator, fit the battery so that its
Spring contacts engage with the contact studs
of the generator and then close the retaining
latches.
2.22.5 Loosen the generator handle retaining
wing nut, set the handle to the winding
position and tighten the wing nut.
2.22.4 Turn the handle. As the turning speed
is increased, the generator indicator lamp
(provided with a sliding shutter for night
operation) will light until a speed is reached
at which the lamp extinguishes. Continue to
turn the handle at this speed to keep the lamp
extinguished.
2.22.5 When using the RT320/1 at a normal
transmit:receive ratio of 1:9, the battery
should remain charged by continuous operation
of the generator. If the normal ratio is
` exceeded, it will be necessary to operate the
generator after the radio is switched off in
order to fully charge the battery.
2.22.6 On completion of an operating period,
return the generator handle to its stowage
position, as shown.