Plessey PRC 320/1 - Functional Checks; Ancillary Equipment

CHAPTER FIVE
CORRECTIVE MAINTENANCE AND FUNCTIONAL CHECKS
GENERAL
5.1 The procedures outlined in this chapter are to
be followed when checking the RT320/1 and its
ancillary equipment. These checks are to be carried
out as part of the preventive maintenance given in
Chapter Four or in the event of equipment failure.
They are designed to enable an operator to prove
quickly that the equipment is functioning correctly
or to localise the fault if it is not. Тһе following
points are to be observed а% all times:-
5.1.1 The operator is not to open sealed
equipment under any circumstances.
5.1.2 The equipment is not normally to be
removed from its parent installation in order
to perform maintenance.
5.1.5 The user is only to take remedial
action where this is stated to be specifically
within his capability.
5.1.4 The user is not to make adjustments or
replace items unless he сап make a confirmatory
test.
FUNCTIONAL CHECKS
5.2 When carrying out the functional checks
following, it is to be ensured that the equipment has
been correctly set up and is being operated in
accordance with the operating information given in
Chapter Two (page 20).
55