Plessey PRC 320/1 - Charging Units

D.C. CHARGING UNITS (Fig.18)
2.24 The d.c. charging units (14V and 28V d.c. input)
are primarily designed to float charge a Clansman
manpack secondary battery used with a vehicle radio.
The charging period is as follows:-
46
2.24.1 Using the d.c. charging unit supply
cable, connect the D.C.INPUT plug (4) to the
appropriate d.c. supply (14V or 28V), ensuring
correct polarity.
2.24.2 Using the battery charging cable,
connect the charging connector on the battery to
the OUTPUT connector (5).
2.24.5 Set the INPUT switch (5) to ON.
2.24.4 Set the LAMPS switch (6) down (on). Тһе
CHARGE PROCEEDING YELLOW lamp (1) will light to
indicate that the battery is properly connected
and is being charged. When the battery is fully
charged this lamp will extinguish and the CHARGE
COMPLETE GREEN lamp (2) wil light. The
approximate charging times from flat are:-
a. 1Аһ battery ії hours
b. 23.5Ah battery 4 hours
2.24.5 Except when connecting the battery, or
inspecting its charge state, set the LAMPS
switch to OFF. No damage to the battery or the
charging unit will occur if а fully charged
battery is left connected.