PLP B20 - Page 15

- 14 -
Hot Restart
To start the engine that is already warmed up (hot restart).
1. Turn the choke lever to the open position, and set the stop switch
to the “ON” position.
2. Leave the throttle trigger in the idle position and pull the starter grip.
3. If the engine fails to start after three to four pulls, follow the instructions
in the Cold Starting Procedure section above.
If the engine fails to start after you follow the above procedures, contact
an authorized PLP dealer.
To Stop the Engine
1. Release the throttle trigger.
2. Slide the stop switch to “STOP” position.
STOP
(
OFF
)
Stop
Switch
START
(
ON
)
Fast-idle Start
Position
Idle
Position
Fast-idle
Start Lock
[B20, B21]
STOP
(
OFF
)
Stop Switch
START
(
ON
)
Fast-idle Start
Position
Idle Position
[Except for B20, B21]
Fast-idle
Start Lock