- 25 -
General Cleaning and Tightening
The PLP Trimmer/Brushcutter will provide maximum performance for many, many hours if it is maintained
properly. Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning
the entire machine.
Storage
For long term storage of the Trimmer/Brushcutter:
1. Empty the fuel tank into a suitable fuel storage container.
2. Run the engine to remove any fuel that may remain in the carburetor.
3. Perform all regular maintenance procedures and any needed repairs.
4. Remove the spark plug and squirt a very small amount of engine oil into the cylinder.
5. Pull the starter grip once.
6. Slowly pull the starter grip to bring the piston to the top of the cylinder (TDC).
7. Reinstall the spark plug.
8. Store the Trimmer/Brushcutter in a dry place away from excessive heat, sparks or open flame.
WARNING
POTENTIAL HAZARD
・When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・Always turn off your Trimmer/Brushcutter before you clean or perform any maintenance on it.
CAUTION
POTENTIAL HAZARD
・Oil may squirt out of the spark plug opening when you
pull the starter grip.
WHAT CAN HAPPEN
・Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
・Protect your eyes and keep your face away from
the spark plug opening.
To Next Page
Loading...
