Cutting with Nylon Trimmer Line
・
The tip of the line does the cutting. The line should stay extended while cutting.
・
Do not force the line into the material. Forcing the line will cause it to slap against the material, increasing line
usage and causing poor cutting results.
Trimming
Hold the bottom of the trimmer head about 5-10cm above the
ground and at an angle. Allow only the tip of the line to make
contact.
Scaling
To remove unwanted vegetation, hold the trimmer head
about 5-10cm above the ground and at an angle. Allow
the tip of the line to strike the ground cutting the
vegetation off at the surface.
Mowing
Keep the line parallel to the ground and use a gentle
side-to-side motion.
5
To Next Page
Loading...
