PLP B20 - Troubleshooting; Specifications

- 26 -
Troubleshooting
Problem Cause Action
Engine will not start
・STOP switch set to off position
・Empty fuel tank
・Engine flooded
・Move switch to on position
・Fill fuel tank
・Use warm engine starting procedure
Engine will not Idle
・Idle speed set incorrectly ・Set Idle speed
Engine lacks power or
stalls when cutting
・Throttle wire has come loose
・Dirty air filter
・Tighten throttle wire
・Clean or replace air filter
If further assistance is required, contact your local authorized PLP service dealer.
Specificaciones
B20 B21 L20 L23 L26 BC26
Dry Weight without fuel, harness
and cutting attachment, kg
※1
4,3 4,1 4,4 4,5 4,8 5,3
Engine displacement, cm
3
19,8 19,8 19,8 22,5 25,4 25,4
Fuel tank capacity, litters 0,6 0,6 0,6 0,6 0,6 0,6
Type of carburetor Diaphragm
Ignition System Solid State
Spark plug NGK BPMR6Y
Electrode gap, mm 0,6 - 0,7
Fuel Mixture 2 – Cycle Oil Mix 25:1 Ratio
Cutting equipment
Grass blade (optional)
Trimmer head (optional)
－
Semi-auto head(R)4
(Auto head
,
Manual head)
(∅230 3-teeth, 4-teeth,8-teeth)
(Auto head , Semi-auto head, Manual head)
L30 L45 BC30 BC45 BC50
Dry Weight without fuel, harness
and cutting attachment, kg
※1
5,4 7,6 5,9 8,2 8,2
Engine displacement, cm
3
30,1 41,5 30,1 41,5 49,9
Fuel tank capacity, litters 0,6 1,0 0,6 1,0 1,0
Type of carburetor Diaphragm
Ignition System Solid State
Spark plug NGK BPMR6Y
Electrode gap, mm 0,6 - 0,7
Fuel Mixture 2 – Cycle Oil Mix 25:1 Ratio
Cutting equipment
Grass blade (optional)
Trimmer head (optional)
(∅255 3-teeth,
4-teeth, 8-teeth)
(Auto head , Semi-auto head, Manual head)
※1. Dry weight without Cutting Attachment, harness and fuel.