63
1. Display Your test results are displayed here. The large, easy to read screen
guides you through the test by using numbers and symbols.
2. M Button The M (mode) button is used to set time, alarm, enters the memory
mode to show the consecutive 7/14/30-day average results and turns the Meter
on and off.
3. S Button The S (select/set) button is used to select year, month, day, time,
memory of results and control solution mode.
4. Test Port This is where you insert the Test Strip into the Meter.
5. Unit Switch Switch for mmol/L or mg/dL.1 mmol/L =18 mg/dL
6. Battery Cover
7. Label
8. Reset Button Press this button to re-set the system.
9. Data Port Connect interface cable to transfer data.
To Next Page
Loading...