Plusmed pM-100 fasTTest - Installing and Replacing the Battery

68
When the battery is low, the Meter will show a warning signal.
When this display appears, it is time to replace a new battery.
When the low battery warning signal is shown, the Meter will pro-
vide accurate results for approximately 50 more measurements.
1. From the back of the Meter, gently lift the battery cover.
2. Insert a 3-Volt Lithium battery (CR-2032) with the “+” side facing up.
3. Close battery cover.
Installing/Replacing the Battery
How to Replace the Battery
1 2 3
Trimpeks İth.İhr.Tur.ve Tic.A.Ş.
Eski Büyükdere Cad. Yunus Emre Sok. No:1/12
4. Levent, 34418 İstanbul Tel +90 212 319 50 00
Fax +90 212 319 50 50, www.trimpeks.com
B04Q102167(03)
Rev. date: 10/2014
Battery/Pil:
Made in Taiwan
Tayvan'da üretilmiştir
Trimpeks İth.İhr.Tur.ve Tic.A.Ş.
Eski Büyükdere Cad. Yunus Emre Sok. No:1/12
4. Levent, 34418 İstanbul Tel +90 212 319 50 00
Fax +90 212 319 50 50, www.trimpeks.com
B04Q102167(03)
Rev. date: 10/2014
Battery/Pil:
Made in Taiwan
Tayvan'da üretilmiştir
Trimpeks İth.İhr.Tur.ve Tic.A.Ş.
Eski Büyükdere Cad. Yunus Emre Sok. No:1/12
4. Levent, 34418 İstanbul Tel +90 212 319 50 00
Fax +90 212 319 50 50, www.trimpeks.com
B04Q102167(03)
Rev. date: 10/2014
Battery/Pil:
Made in Taiwan
Tayvan'da üretilmiştir
Trimpeks İth.İhr.Tur.ve Tic.A.Ş.
Eski Büyükdere Cad. Yunus Emre Sok. No:1/12
4. Levent, 34418 İstanbul Tel +90 212 319 50 00
Fax +90 212 319 50 50, www.trimpeks.com
B04Q102167(03)
Rev. date: 10/2014
Battery/Pil:
Made in Taiwan
Tayvan'da üretilmiştir