PMDG 737NGX 0.00.11
TUTORIAL #2
For Simulator Use Only DO NOT DUPLICATE 27FEB15 RTM
P3D SETUP
Tutorial #2 is designed to pick up literally right where Tutorial #1 left off. If
you’ve just flown Tutorial #1 and are ready to move on, there’s nothing
else you have to do, we’ll start right from the same gate we just parked at
in Amsterdam without leaving the simulator. This is simulating what’s
known as a “short turn” in airline lingo. As a pilot you’d likely have
deplaned briefly and grabbed a bite to eat and stretched your legs in the
terminal before preflighting the next leg of the day’s flying.
Normally, most of the aircraft’s systems would be left running for a short
turn, however for the purpose of learning the procedures we did a full
“cold and dark” shutdown of the aircraft at the end of Tutorial #1. We’ll be
going through the full preflight procedures this time, just as a crew would
do on the first flight of the day.
Loading the saved flight:
If you are starting from the end of Tutorial #1 with P3D still running, skip
this short section on loading the Tutorial #2 saved flight and go straight to
ELECTRICAL POWER UP below.
Start P3D and navigate to the Create Scenario screen (Flights,
Create Scenario) if it is not up by default.
Click the “Load” button.
Select the flight “PMDG 737NGX Tutorial #2 EHAM-LOWI”
The sim will load and put you in the cockpit at the same position we left
off from at the end of Tutorial #1.
Note – the loading may take a long time and it may appear to hang after it
finishes. If this happens, Alt-Tab to select P3D, then press Alt-Enter and it
should bring it back to life.
To Next Page
Loading...