0.00.116 PMDG 737NGX
TUTORIAL #2
27FEB15 RTM DO NOT DUPLICATE For Simulator Use Only
Turn ON the FASTEN BELTS switch on the lower overhead prior
to crossing over the mountains – it’s likely to get bumpy and we
want everyone seated by this point.
At around 9nm from MANAL at FL190 or so you’ll start to pick up
the RTT NDB on the ADF.
Notice the needle realistically swinging and wandering on the
RMI. This was custom programmed based on the real life
behavior and physics of these kinds of radio signals.
Set the ND range as required during the approach. 20nm and
10nm are good values for the initial approach and then you can
switch to 5nm if need be during the later sections.
Passing our transition level of FL120, press the STD button on
the BARO knob to switch to flying altitudes instead of flight levels.
The plane will level out at 10000 feet to slow to 240 knots
somewhere between TULSI and RTTNB.
Passing 10000 feet, turn on the landing lights with a left click of
the gang-bar.
Run the APPROACH CHECKLIST located on page NC.3 of the
QRH. (page 27 of the PDF version)
To Next Page
Loading...