0.00.14 PMDG 737NGX
TUTORIAL #2
27FEB15 RTM DO NOT DUPLICATE For Simulator Use Only
Schiphol tries to minimize use of the APU on the ground for noise
abatement reasons, so we’ll connect the Ground Power and the Air
Conditioning cart for now. We’ll start the APU later in the preflight
process.
Verify both PACKS are OFF on the pneumatic panel, located on
the right center side of the lower overhead.
This comes from the Ground Conditioned Air Use supplemental
procedure located on page SP.2.2 (page 178 in the PDF). The
reason for this is that the air from the cart enters the plenum
downstream from the pack outlets and if the packs were
supplying air too the higher pressure would cause backflow
through the hose and into the air conditioning carts. See the
description/schematic of the pneumatic system in FCOM Vol. 2
for more information.
Pan down and lower the captain’s yoke by left clicking it so we
can see the FMC CDU clearly.
Pan down to the captain’s FMC CDU and press MENU, followed
by FS ACTIONS, then GROUND CONNECTIONS.
Press LSK 2L to connect GROUND POWER and LSK 4L to
connect the AIR CONDITIONING UNIT.
To Next Page
Loading...