PMDG 737NGX 0.00.79
TUTORIAL #2
For Simulator Use Only DO NOT DUPLICATE 27FEB15 RTM
Set the takeoff trim. It should be around 5.03 in our case. The
value should be present at line 3 on the captain’s CDU.
o Verify that this trim value is in the green band.
As with Tutorial #1 it’s not important that this setting on
the trim scale is 100% exactly what the FMC says, it just
needs to be close to that value.
Verify that the aileron and rudder trim settings on the pedestal are
both 0.
Run the BEFORE START CHECKLIST located on page NC.1 of
the QRH. (page 25 in the PDF version)
To Next Page
Loading...