0.00.90 PMDG 737NGX
TUTORIAL #2
27FEB15 RTM DO NOT DUPLICATE For Simulator Use Only
Set the AUTO BRAKES switch to OFF
Set the LANDING GEAR lever to the middle OFF position after
retraction is complete.
Set both engine start switches on the lower overhead to OFF.
We’re above our engine out acceleration height with no engine
failure present, so press the RST (reset) switch on the EFIS
MINS knob to remove the 989 foot BARO height from the PFD.
Select the LEGS page on the captain’s CDU for easier reference
and for any potential editing later. Select the PROG page on the
first officer’s CDU for monitoring.
Run the AFTER TAKEOFF CHECKLIST located on page NC.2 of
the QRH. (page 26 of the PDF version)
To Next Page
Loading...