Instruction book
9828 0931 61 29
8. Push and release the UP button (9).
9. Message “y” appears on display.
10. Push and release SET (8) to reset service alarm.
1
1. Message “y” blinks for 3 seconds.
12. Then “rL” is fixed and “°C” blinks on display for about 10 seconds.
The service alarm is now reset.
Setting the service interval
To set the service interval, follow steps 1 to 9:
1. PDP is showing standard view.
2. Push and hold buttons SET (8) and DOWN (10) to enter the menu.
3. Message “SE” appears on display.
4. Push and release SET (8) to enter the “SE” menu.
5
. Current service interval is displayed.
(“60” or any other value between “0” and “99”)
6. Select desired service interval using the UP and DOWN button.
(
40=4000h, 55=5500h, 80+8000h,…)
7. Push and release SET to confirm the new service interval.
8. The selected value blinks during 3 seconds.
To Next Page
Loading...
