(4)
PDP switching temperature
(5)
PDP Alarm offset
(6) Heatless backup mode (see note *)
(7)
Not activated
(8)
Modify
*: not applicable.
• The screen shows the list of all settings.
• Press the Enter button (2); a red selection bar is covering the first item (PDP extended cycle).
Use the ↓ key of the Scroll keys to select the setting to be modified and press the Enter key.
• A pop-up screen appears. Use the ↑ or ↓ key to select the required parameter and press the Enter key
to confirm.
Regulation settings:
• PDP extended cycle: the cycle is lengthened by putting the vessel in waiting mode (standby) if PDP
is low enough after regeneration and cooling. The extended cycle should only be activated when a
working PDP sensor is present.
• PDP switching temperature: the PDP should not increase to this setting before the vessels are
switched when the dryer is in standby mode.
• PDP Alarm offset: the PDP alarm is active when: PDP > PDP_switching_temperature +
PDP_alarm_offset. In that way, the alarm threshold can be set independently of the switching
threshold.
Automatic restart
• Select the Automatic restart settings icon as described above and press the Enter button (2).
Following screen appears:
Text on figure
(1)
Automatic restart (Not Activated)
(2)
Maximum power down time
(3)
Restart delay
(4)
Modify
• The screen shows the list of all settings.
• Press the Enter button (2); a red selection bar is covering the first item (Automatic restart).
Use the ↓ key of the Scroll keys to select the setting to be modified and press the Enter key.
Instruction book
2920 1891 00 33
To Next Page
Loading...
