Pneumercator LC1000 SERIES - Page 11

LC1000 INSTRUCTION MANUAL PRODUCT DESCRIPTION
PAGE 11
Figure 1-7 – LS600 Series
(Refer to Bulletin 193 for Installation/Operation/Testing Instructions)
Commonly used for Overfill Protection
May also be used for Low alarms and Indirect Pump On/Pump Off Conditions
See PC1000 literature for direct pump control applications
DRAWING NO. 20057 REV.
A
SL
1/2" NPT THREADED OPENING
MAX. DIA. 1.63"
3" REF
S.S. RETAINING CLIP
2 REQ'D PER FLOAT
LIFT GUIDE
SL
ADDITIONAL LIFT GUIDE FOR
UNITS WHERE SENSING
LENGTH "SL" EXCEEDS 18"
2" REF
(3" REF WHEN
FLOAT IS
LIFTED)
5" REF.
51/2"
REF.
S.S. OR BRASS
FITTING
S.S. FLOAT
MAX. DIA. 1.92"
S.S. RETAINING CLIP
2REQ'DPERFLOAT
S.S. OR BRASS
FITTING
S.S. OR BRASS
FITTING
S.S. OR BRASS
FITTING
(2) 2' LONG (10' FOR LS600A MODELS)
18 AWG WIRE LEADS PER
FLOAT SWITCH
(2) 10' LONG 18 AWG
WIRE LEADS
ADDITIONAL
FLOATS FOR
CUSTOM UNITS
S.S. OR BRASS SHAFT
MAX. LENGTH 192" S.S.
AND 144" BRASS
SEAL FITTING
S.S. LIFT ROD
BUSHING
(2" NPT)
LS600A NCL
L
S
600, L
S
600 O
W
OR LS600A *
BUNA-N FLOAT
DIA.1.75"
S.S. OR BRASS SHAFT
MAX. LENGTH 192" S.S.
AND 144" BRASS
BUSHING
(2" NPT)
NIPPLE
HOUSING
3" MIN.
3" MIN.
1/2" MIN.
4"
REF
1/2" MIN.
OPTIONAL S.S. FLOAT FOR
2" OR 1 1/2" NPT OPENINGS
INSIDE WALL OF
TANK BOTTOM
L
L
S*
5/8" THREAD
ENGAGEMENT
S*
5/8" THREAD
ENGAGEMENT
3" REF.
* LS600 OW SERIES SUPPLIED WITH STAINLESS FLOATS.
HOUSING, NIPPLE & BUSHING NOT SUPPLIED ON LS600A SERIES.
CUSTOM MINIATURE LS600s ARE AVAILABLE FOR SUB
BASE OR GENERATOR TANKS THAT REQUIRE SET
POINTS TO BE CLOSER TOGETHER AND/OR TANKS
WITH SMALLER THREADED OPENINGS. SEE OUTLINE
DRAWING 10620.
NOTE