Pneumercator LC1000 SERIES - Other Dry Contact Float Switches

LC1000 INSTRUCTION MANUAL INSTALLATION DETAILS
PAGE 19
Figure 2-5 - Dry Leak Sensor Installation in Fiberglass Tanks
2.6 OTHER DRY CONTACT FLOAT SWITCHES
The LC1000 has the electrical ability to read the continuity state of any dry contact sensor. As such,
this system will support a variety of sensors from various manufacturers. However, your local
regulations may not permit this combination as the LC1000 has not been specifically approved for
use with sensors not manufactured by Pneumercator. Please consult with your local regulators and
with Pneumercator to discuss the compatibility of your particular sensor with the console and
application.
Some Pneumercator float switch sensors have been covered in their entirety within this Instruction
Manual. Select models have separate Instruction Bulletins for specific installation and wiring
instructions. Please see the list below for the specific bulletin numbers:
RSU800-2 Bulletin 134
LS600 Series Bulletin 193
LS600-S Bulletin 195
2-wire splice kit Bulletin 179
3-wire splice kit Bulletin 180
These bulletins were supplied with each sensor and may also be downloaded from the internet at
www.pneumercator.com in the Tech Support section.
DRAWING NO. 20018 REV.
D
RISER PIPE CAP W/
LIQUID TIGHT CABLE GRIP
WATERTIGHT JUNCTION BOX AND
VAPOR SEAL
1
/
2
"
N
P
T
L
I
Q
UI
D
T
I
G
H
T
C
A
B
L
E
G
R
I
P
(USE 1/2" X 3/8" NPT REDUCER FOR 3/8" CABLE GRIPS)
1/2" OR 3/4" CONDUIT TO CONSOLE
LEAK SENSOR CABLE
MANHOLE
RISER HEIGHT
PULL CORD
TANK ANNULUS
LEAK SENSOR
COIL & SECURE EXCESS PULL COR
D
DO NOT REMOVE THE PULL CORD
4" SCHEDULE 40 OR
2" SCHEDULE 40
RISER PIPE
OPTIONAL PADLOCK
(BY CUSTOMER)