INSTRUCTIONS
Step 1: Replace the dust bag.
When the dust bag is full, replace it as promoted on the cleaning base station’s
display. It is suggested to make the replacement every four weeks.
Step 2: Clean the dust passage.
Disconnect the power supply and
check whether the transparent dust
passage, and the dust inlet are
blocked. In the case of blockage,
please remove the foreign matter(s)
in time.
Step 3: Clean the infrared lens, and
the charging contact.
Use a clean soft cloth to wipe any
foreign matter on the infrared lens,
and the charging contact.
Transparent dust
passage
Dust inlet
Infrared lens
Charging contact (×2)
Open the
cleaning base
station’s top
cover.
Lift the dust
bag handle
and dismount
the dust bag.
Insert the
mouth of the
dust bag into
the cleaning
base station’s
limit slot.
Mount a
new dust
bag.
Mount the
cleaning
base
station’s top
cover again.
19
To Next Page
Loading...
