What does it mean if the water shortage indicator is on for my humidifier?
If the water shortage indicator is on, refill the water tank and wait at least one minute. It's also possible that the water level hasn't yet reached the vaporization compartment, so wait at least one minute. Check the positioning of the tank on the base, and make sure the humidifier is on a flat surface.
Why is the battery/charging indicator light blinking on my Vacuum Cleaner?
If the battery or charging indicator light is blinking on your Vacuum Cleaner, it likely means the vacuum cleaner is out of power. Recharge it to its full capacity, and the blinking light should stop.
What to do if my Vacuum Cleaner is not charging?
If your Vacuum Cleaner is not charging, first ensure that the main power supply switch is turned on. Also, do not use the power cord if it is damaged. Contact an authorized repair department for maintenance.
What to do if Vacuum Cleaner turns off and charging indicator is blinking red/purple?
If your device turns off and the charging indicator is blinking red or purple, the roller brush may be jammed. Clean the brush to resolve this issue.
Why isn't the warm mist function working on my humidifier?
If the warm mist function on your humidifier isn't producing warm mist, first wait a few minutes to allow it to complete the warm-up phase. If the mist is too fine to feel the warmth, increase the speed level. If the room temperature is too cold, increase the speed level and heat the room up.
Why is mist coming out from the base of my humidifier?
If mist is coming out from the base of your humidifier, it's likely that the water tank is not positioned correctly. Turn off and unplug the humidifier, then align the water tank cover with its respective opening in the inner chamber.
Why does white dust appear around my humidifier?
If white dust appears around your humidifier, it's often due to high mineral content in the water. Try using distilled, purified, or filtered water instead. Also, remember to clean the water tank at least once a week. The humidifier may also need cleaning if it wasn't properly cleaned after the last use.
Why does my humidifier smell bad?
If your humidifier produces an unusual smell, it could be due to several reasons. If the humidifier is new, take out the water tank, open the cover, and let it stay in a cool place for 12 hours. If you've been using dirty water or the water has been sitting for too long, clean the water tank and fill it with clear water. If you've been diffusing aroma oil, the smell may be residual. In this case, remove the aroma cotton, rinse it under clean water, and let it dry.
Why is my humidifier displaying the wrong humidity level?
If the humidity level being displayed is incorrect, it could be due to several reasons. If the room is larger than the effective range of the humidifier, move it to a room within the suitable size. If moisture has built up inside the humidity sensor, turn off the humidifier and allow the sensor to completely air dry before resuming use. Also, ensure the nozzle isn't facing the direction of the humidity sensor; turn it away. It's also possible that the humidity sensor is broken or defective, in which case you should contact Customer Support.
What to do if there is water on the floor near my Point Dehumidifier?
If you find water on the floor near your Point Dehumidifier, it could be due to a few reasons. The drain connection may be aging or loose, so check the drain connection and ensure the appliance is placed on a level surface. If you're using a drain pipe, but water isn't draining, remove the drain pipe and put back the drain cover, or install the drain pipe correctly.
Essential safety rules for proper and safe domestic use of the vacuum cleaner.
Cautions for Li-ion batteries, transportation, and proper storage conditions.
Key considerations during vacuum operation, disposal guidelines, and packaging information.
Labeled diagram identifying all parts and accessories of the vacuum cleaner.
Steps for wall mounting the docking station and ensuring secure installation.
Initial charging procedure for the vacuum cleaner battery and understanding charging indicators.
Information on battery recycling and interpreting various charging LED status lights.
How to attach different accessories like tubes, nozzles, and brushes to the main unit.
Understanding the power status and speed mode indicators during operation.
Instructions for using crevice/mini brush, crevice holder, and brush rollers.
Steps for filter changes, dust container cleaning, mattress brush, and floor nozzle maintenance.
Solutions for common problems such as power, charging, and suction issues.
Explanation of LED indicators for various operational and battery states.
Key technical details of the vacuum cleaner model.
General| Brand | point |
|---|---|
| Model | pro Series |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
