What to do if my Vacuum Cleaner is not charging?
If your Vacuum Cleaner is not charging, first ensure that the main power supply switch is turned on. Also, do not use the power cord if it is damaged. Contact an authorized repair department for maintenance.
What to do if Vacuum Cleaner turns off and charging indicator is blinking red/purple?
If your device turns off and the charging indicator is blinking red or purple, the roller brush may be jammed. Clean the brush to resolve this issue.
What to do if Coffee Grinder powers off automatically?
If your Coffee Grinder powers off automatically after running continuously for 240 seconds, unplug the power cord and allow the unit to cool down. After it has cooled, you can restart it.
How to fix the E1 error on Coffee Grinder?
If the display shows error code E1, it indicates that the bean box is either not assembled or not tightly connected. To resolve this, assemble the bean box or tighten it until the micro switch is closed. Once the bean box is properly closed, the error code E1 should disappear.
What to do if my Point Dehumidifier does not start?
If your Point Dehumidifier doesn't start, several factors could be the cause. First, ensure the dehumidifier is fully plugged into the outlet. Check your house fuse or circuit breaker and replace the fuse or reset the breaker if needed. Also, the dehumidifier might have reached its present level, or the tank could be full; in this case, change to a lower setting or empty the water tank and replace it properly. Make sure the tank is correctly placed and securely seated. Finally, if there was a power failure, there's a protective time delay of up to 3 minutes to prevent tripping of the compressor overload; wait for 3 minutes after powering back on.
Why Point Dehumidifier does not dry the air properly?
If your Point Dehumidifier isn't drying the air as expected, several things could be happening. If newly installed, allow at least 24 hours for it to reach the desired dryness. Ensure that curtains, blinds, or furniture aren't blocking the front or back of the unit. The filter might be dirty, so clean it. The Humidity Control might not be set low enough; lower the desired humidity or set the dehumidifier for maximum dehumidification. Check that all doors and windows are securely closed. Ensure your clothes dryer isn't blowing moist air into the room, and if so, move the dehumidifier away from the dryer, and vent the dryer outside. Lastly, lower room temperatures will reduce the moisture removal rate; this model operates best above 5°C (41°F).
Why does my Point Dehumidifier run too long?
Your Point Dehumidifier might run for extended periods if the area it's trying to dehumidify is too large for its capacity. Another reason could be that doors and windows are open, so close them to improve efficiency.
Why is the suction power of my Vacuum Cleaner decreasing?
If your vacuum cleaner's suction power is decreasing, start by checking the crevice tools and tube for any blockages. Clear any obstructions you find. Also, a dirty filter can reduce suction. Try cleaning the filter, and for best performance, consider replacing it.
Why does frost appear on the heat exchanger of my Point Dehumidifier?
The appearance of frost on the heat exchanger of your Point Dehumidifier is normal if the appliance has recently been running or if the room temperature is low. The frost should disappear within 60 minutes.
Why is my Point Dehumidifier making fan noise?
The fan noise from your Point Dehumidifier is normal, as it is caused by air passing through the appliance.
Essential safety rules for proper and safe domestic use of the vacuum cleaner.
Cautions for Li-ion batteries, transportation, and proper storage conditions.
Key considerations during vacuum operation, disposal guidelines, and packaging information.
Labeled diagram identifying all parts and accessories of the vacuum cleaner.
Steps for wall mounting the docking station and ensuring secure installation.
Initial charging procedure for the vacuum cleaner battery and understanding charging indicators.
Information on battery recycling and interpreting various charging LED status lights.
How to attach different accessories like tubes, nozzles, and brushes to the main unit.
Understanding the power status and speed mode indicators during operation.
Instructions for using crevice/mini brush, crevice holder, and brush rollers.
Steps for filter changes, dust container cleaning, mattress brush, and floor nozzle maintenance.
Solutions for common problems such as power, charging, and suction issues.
Explanation of LED indicators for various operational and battery states.
Key technical details of the vacuum cleaner model.
General| Brand | point |
|---|---|
| Model | pro Series |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
