1. Avoid using this appliance in a room with infants and pets, and keep away from
infants and pets to avoid danger.
2. In order to facilitate the robot to return to the cleaning base station after cleaning,
it is recommended that the robot start from the cleaning base station and the
cleaning base station is not moved during cleaning.
3. The cleaning base station has the functions of collecting dust, charging, cleaning
mop and air-drying mop. A new dust bag has been installed before packing.
4. Do not use the mop on carpet.
PRODUCT OPERATION
ATTENTION
Step 4: Take out the clean water
tank, remove the cover of
the clean water tank, put
the clean water tank after
adding water back to the
cleaning base station, and
cover the top cover of the
cleaning base station.
Step 3: Find a suitable place to place
the cleaning base station,
and ensure that the cleaning
base station is placed
horizontally.
power and pair the robot with the base station. You need to press the
"On/Off key + partial cleaning key" on the robot for 5 Seconds, and
the "Start key + recall key” on the base station for 5 Seconds. You will
have 1 minute to pair. After successful pairing, the mainframe is
Step 5: As the base station is shown in the picture below. Connect the
placed on the base station for charging.
Longer than 0.5 m
Longer than 1.5 m
Water injection
Partial cleaning button
On/o button
Recharging button
Longer than
0.5 m
9
To Next Page
Loading...
