2-1
SECTION 2 – INSTALLATION AND SET UP
PREPARATION FOR USE
2.1 Unpacking
The instrument is shipped in a sturdy transit pack. Open the pack carefully and remove the instrument
and its accessories.
The TONEOHM 950 carton should contain the following:
TONEOHM 950
Needle probes
Current Trace Probe / Drive Source lead assembly
Plane Probe / Clip assembly
Set of four Plane Stimulus leads
Headphones
Operator manual
Power cord
Retain the packaging for possible future use.
NOTE: If the instrument has been shipped or stored in a cold environment, allow the instrument to reach
the temperature of its new location before applying power.
2.2 Connecting the TONEOHM 950 to a power supply
Refer to the voltage label on the rear panel of the instrument and make sure that the marked
rating is suitable for the local mains power supply.
If the rating on the label is not suitable for the local power supply refer the instrument to a skilled
electronics technician. Instructions for changing the line voltage settings are contained in the TONEOHM
950 Service Manual.
Note: If a special local plug must be fitted to the power cord ensure this operation is performed by a
skilled electronics technician and that the protective ground connection is maintained. The plug that is cut
off from the power cord must be safely disposed of.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...