50
OPERATION
Break-in Period
The break-in period for your new Polaris Sportsman 6x6 is defined as
the first ten hours of operation or the time it takes t o use the first two
tanks of gasoline. No single action on your part is as important as
following procedures for a proper break-in period. Careful treatment of
a new engine will result in more efficient performance and longer life
for the engine. Perform the following procedures carefully.
CAUTION
Excessive heat build-up during the first three hours of operation
will damage close-fitted engine parts and drive components. Do
not operate at full throttle or high speeds during the first three
hours of use.
Lack of proper lubrication will cause serious engine damage.
Always check the oil level when refueling the vehicle.
Engine and Drivetrain Break-in
1. Fill the fuel tank with either unleaded or leaded fuel that has a
minimum pump octane number of 87= (R+ M)/2.
2. Check the oil reservoir
level indicated on the
dipstick. Add the
recommended oil as
needed to bring t he level
within the normal range (1).
3. Drive slowly at first. Select an open area that will allow room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions.
5. Perform regular checks on fluid levels, controls, and areas outlined
on the daily pre-ride inspection checklist. See page 51.
6. Pull only light loads during t he break-in period.
7. Perform a break-in oil change at 20 hours or one month, whichever
comes first.
PVT Break-in (Clut ch es/Belt)
A proper break-in of t he clutches and drive belt will ensure a longer
life and better performance. Break in the clutches and belt by
operating at slower speeds during the break-in period as recommended.
Pull only light loads. Avoid aggressive acceleration and high speed
operation during the break-in period.
ADD 8 OZ. NORMAL FULL
1
To Next Page
Loading...
Need help?
General
