Polaris 9350 - Transport Caddy Assembly; Connecting Control Unit to Caddy

!"#$%`
English
3. Push base unit down (Figure 3) so the metal
handle frame is seated in the recess on the
underside of the base.
1BM;<>([S( 8:CC>H=()>=AE(1<AG>(=:(nAI>(+CB=
4. Slide the handnut over the tube and twist to
tighten onto base unit (Figure 4).
1BM;<>(^S( 6XBI=(/ACFC;=(=:('>H;<>(1<AG>
 6QDSWZRVXSSRUWEORFNVLQWRSODFH
)LJXUH
6. Slide axle and hubcap piece through center of
wheel and attach to base unit. Snap locking clip
into place to secure wheel. Repeat to attach both
ZKHHOV)LJXUH
1BM;<>(\S( 'CA?(BC(';??:<=(nE:HqI(ACF(*==AHL(
"L>>EI
7. Slide the control unit base / caddy handle
attachment down over the metal tubing until it
snaps into place. (See Figure 6).
1BM;<>(gS( *==AHL(8AFFW(/ACFE>