Why does my Polaris Swimming Pool Vacuum not climb the pool sides?
Your Polaris Swimming Pool Vacuum might not be climbing the pool sides because the filter canister is full or dirty, so you should clean it. Also, the pool sides could be slippery due to microscopic algae. In this case, perform a shock chlorination treatment and slightly reduce the pH, but be sure to remove the cleaner from the pool during this treatment.
What to do if my Polaris 9350 Sport Swimming Pool Vacuum doesn't stay on the pool bottom?
If your Polaris Swimming Pool Vacuum isn't staying firmly on the pool bottom, it might have air trapped in the casing, so submerge the cleaner completely. Alternatively, the filter canister might be full or dirty, so clean the filter canister.
What to do if my Polaris 9350 Sport doesn't move on startup?
If your Polaris Swimming Pool Vacuum doesn't move on startup, ensure the outlet the control unit is connected to is receiving electrical power. Also, check that you have started one of the two programs and that the indicator for the selected program is lit. If the indicator light is not lit, turn the wheels then disconnect the control unit and wait at least 20 seconds before reconnecting. If the problem persists, contact Polaris Technical Support at (USA) 1-800-822-7933.
How to stop my Polaris 9350 Sport Swimming Pool Vacuum cable from tangling?
To prevent your Polaris Swimming Pool Vacuum cable from tangling, avoid unraveling the entire cable length; place only the necessary amount in the water, leaving the rest on the pool side. Also, the brushes may be worn, indicated by smoothness or a 'wear' indicator, so replace them. A full or dirty filter canister can also cause tangling, so clean the filter canister.
Why is my Polaris 9350 Sport flashing lights after starting?
If the lashing indicator lights or an error code appear on your Polaris Swimming Pool Vacuum just after starting, the floating cable may not be correctly plugged into the control unit, so unplug and reconnect it. The cleaner might also not be fully submerged, so remove it from the pool and re-submerge it. Also, try resetting the cleaner by pressing the power button OFF, then Cycle I or Cycle II to begin a new cycle. If the propellor or wheels may be jammed, contact Polaris Technical Support at (USA) 1-800-822-7933.
What does it mean when the lights are flashing on my Polaris 9350 Sport during the cleaning cycle?
If the lashing lights appear on your Polaris Swimming Pool Vacuum during the cleaning cycle, the cleaner may be sucking in air. This will cause the lights to appear after 60 seconds of air intake. Remove the cleaner from the pool and re-submerge it.
General| Brand | Polaris |
|---|---|
| Model | 9350 Sport |
| Category | Swimming Pool Vacuum |
| Language | English |
Guidelines to prevent electric shock hazards when using the cleaner and control unit.
Safety measures to protect children from harm and prevent drowning incidents.
Important warnings and cautions regarding pool equipment damage or personal injury.
Steps for safely connecting the cleaner's control unit to the electrical power supply.
Setting up multiple cleaning cycles for specific days and times.
Detailed steps for cleaning the cleaner's filter canister after each use.
Interpreting LED flashes to diagnose malfunctions on the 9350/P935 cleaner.
Accessing and understanding status screens for troubleshooting the 9450/P955 models.
To Next Page
