119
Maintenance
Lights
Headlight Assembly Replacement
1. Remove the front cover.
2. Remove the wire harness connector from the headlight.
3. Remove the two retaining brackets and the adjuster screw.
4. Remove the headlamp.
5. Install the new headlamp, placing it in the slots on the frame tabs. Secure the headlamp
with the retaining brackets.
6. Install the adjuster screw, leaving it loose so the headlight can be adjusted.
7. Connect the wire harness to the headlamp. Reinstall the front cover.
8. Adjust the lamp as needed (see page 116), then tighten the adjuster screw.
To Next Page
Loading...
Need help?
General
