Page 14
English
Store the Cleaner When Not in Use
The cleaner must be cleaned regularly using slightly soapy clean water. Do
not use solvents such as trichlorethylene or its equivalent. Rinse the cleaner
generously using clean water. Do not let your cleaner dry in direct sunlight near
the pool.
1. Disconnect cleaner from the power source.
2. Starting at the cleaner head, remove all coils and tangles from the oating
cable (Figure 14). Lay the cable in the sun to loosen any tangling memory.
3. Disconnect the cable from the control unit. Replace the protective cap on
the control unit.
Figure 14. Untangle the Floating Cable
4. Loosely coil the oating cable starting at the cleaner and moving toward
the connection point at control unit.
5 Maintenance
WARNING
To avoid electric shock and other hazards which could result in permanent
injury or death, disconnect (unplug) the cleaner from the power source before
performing any cleaning and maintenance.
Cord Tangling
For optimal patterning and reduced tangling, the oating cable should enter the
water near the middle of the pool length (see Figure 15). Spread all of the oating
cable carefully in the pool, ensuring there are no kinks or coils.
To Next Page
Loading...
Need help?
General
