Polaris Power P1000i User Manual

60
TRANSPORTATION AND STORAGE
Storage
9. Remove spark plug cap (C).
10. Pull starter grip (D) three to four
times to drain the petrol from the
fuel pump and into a suitable
container.
11. Position engine switch (E) to
OFF (see page 18) and tighten the
carburetor drain screw.
12. Re-install spark plug cap on the
spark plug securely.
13. Re-install the top of the unit and
the service door.
Fogging the Engine
1. Remove the top of the unit to access the spark plug, see page 54.
2. Remove the spark plug cap (A).
3. Using a spark plug wrench, remove spark plug.
4. Pour about a tablespoon of clean engine oil into the cylinder. Crank
the engine several revolutions to distribute the oil and then reinstall
the spark plug.
C
ON
OFF
D
E
A

Polaris Power P1000i Specifications

General

Brand	Polaris
Model	Power P1000i
Category	Portable Generator
Language	English