61
TRANSPORTATION AND STORAGE
Storage
Fogging the Engine
5. Ensure that the spark plug sealing washer is in good condition and
hand-tighten the spark plug to prevent cross-threading. Torque to
specification on page 62.
6. Re-install the spark plug cap (A) and the top of the unit.
Storage Precautions
Do not store the generator outdoors in the cold weather when not in use.
• Select a well-ventilated storage area away from any flame-operated
appliance (i.e., furnace, water heater, or clothes dryer). Also avoid
any area with a spark-producing electric motor, or where power tools
are operated.
• If possible, avoid storage areas with high humidity to prevent rust and
corrosion.
• Place the generator on a level surface. Tilting can cause fuel or oil
leakage.
• With the engine and exhaust system cool, cover the generator to
prevent dust contamination. Do not use a sheet plastic as a dust cover.
Nonporous covers trap moisture around the generator, promoting rust
and corrosion.
• Unless fuel tank has been completely drained, position fuel tank cap
vent lever to OFF to reduce leakage possibilities.
Removing from Storage
Note: If the cylinder was coated with oil during storage preparation, the engine
may smoke briefly at startup. This is normal.
1. Perform “Pre-Operation Checklist”. See page 25.
2. If fuel was drained during storage preparation, fill tank with fresh
petrol (see page 26). If petrol is stored in a container, ensure the
petrol is fresh. Petrol oxidizes and deteriorates over time, causing
hard starting.
To Next Page
Loading...
Need help?
General
