MAINTENANCE
2.7
LUBRICATION
1. Engine Oil and Filter ¡
2. Brake Fluid ©
(Right hand and Foot
Brake Master Cylinder)
3. Rear Drive Chain
Ill.
#
Item Lube Rec. Method Frequency*
1. Engine Oil /
Transmission
Polaris PS--4
Synthetic
Check dipstick and add to
proper level.
Perform break-in oil/filter change at one
hour; change oil every 10hrs/100mi.¡
2. Brake Fluid Polaris
Dot 3 Brake Fluid
Fill master cylinder reservoir to in-
dicated level inside reservoir.
See Ch. 6.
As required. Change fluid every
2 years or 200 hours.©
3 Drive Chain Polaris Chain Lube Apply to chain link plates and rollers. As required*
* More often under severe use, such as operation in mud, water, sand or under severe loads.
¡ Every 10 hours of operation (refer to Maintenance Schedule for additional information) Change more
often in extremely dirty conditions (continuous operation in water, mud or sand), continuous hot, cold, or short
trip cold weather operation. NOTE: Excessive clutch plate residue will accelerate oil change intervals
© Every 24 months or 200 hours of operation (refer to Maintenance Schedule for additional information)
More often under severe conditions (continuous operation in water, mud or sand)
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
