86
MAINTENANCE
POLARIS Variable Transmission (PVT) System
Belt Replacement/Debris Removal
If a belt fails, always clean any debris from the PVT intake and outlet
duct and from the clutch and engine compartments when replacing the
belt.
WARNING! Failure to remove ALL debris when replacing the belt could result in
vehicle damage and severe injury or death.
1. Remove the clutch cover screws and open the clutch cover. Remove
all debris wrapped in and around the PVT system.
2. Remove all debris from the entire clutch air duct passage.
3. Check for signs of damage to seals on the transmission and engine.
See your POLARIS dealer promptly for service if any seals appear
to be damaged.
Tip: Belt slip is responsible for creating excessive heat that destroys belts,
wears clutch components and causes outer clutch covers to fail. Switch to
low range while operating at slower speeds to extend the life of the PVT
components (belt, cover, etc.).
To Next Page
Loading...
Need help?
General
