FINAL DRIVE
7.22
7. Install the armature plate (D) and spacer washer
(E) into the output cover. NOTE: Be sure
backlash plate is in place.
E
D
Backlash Plate
8. Install the retaining ring (F) into the output cover.
Be sure the retaining ring is properly seated into
the cover.
F
9. Install the ring gear onto the output hub on the
output cover.
G
10. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.
11. Install the output cover assembly onto the main
gearcase.
NOTE: Be sure armature plate tabs are placed into
the slots on roll cage. (See Reference Photo)
Photo for reference only!
Armature Plate Tabs Fit Into Rollcage Slots
NOTE: This photo is for reference only, the armature
plate is actually installed in the output cover.
12. Install output cover with new o-ring and torque
bolts to 14 ft. lbs. (19 Nm).
To Next Page
Loading...
