BRAKES
9.17
REAR BRAKE PAD
INSTALLA
TION
1. Install new brake pads in caliper body.
Install Pads
2. Tighten the slide pin with a hex wrench.
3. Install the slide bolt snap ring. Torque the slide pin
to 30--35 ft. lbs. (41 Nm--48 Nm).
Caliper Slide Pin Torque:
30--35 ft. lbs. (41 Nm--48 Nm)
Torque
Slide Pin
4. Install caliper and torque the mounting bolts.
Torque Mounting
Bolts
Rear Brake Caliper
Torque: 18 ft. lbs. (25 Nm)
5. Slowly pump the brake lever until pressure has
been built up. Maintain at least 1/2″ (12.7 mm) of
brake fluid in the reservoir to prevent air from
entering the master cylinder.
6. It is recommended that a burnishing procedure be
performed after installation of new brake pads to
extend service life and reduce noise. Start
machine and slowly increase speed to 30 mph.
Gradually apply brakes to stop machine. Repeat
procedure 10 times.
To Next Page
Loading...
