ELECTRICAL
10.32
Lens Cover
Bulb
1. From the rear of the taillight remove two screws
holding lens cover in place and remove lens
cover.
2. Remove lamp and replace it with recommended
lamp. Apply Dielectric Grease (PN 2871329).
3. Reinstall the lens cover removed in step 1.
4. Test the taillight/brakelight to see it is working.
HEADLAMP SWITCH
Remove the headlight pod cover. Probe the
headlamp plug wires (Brown and Yellow) at back of
connector. Turn headlight on.
Headlamp Plug Wires
Brown
Yellow
BRAKE LIGHT SWITCH
1. Remove the front cover.
Brake Lamp Switch
Brake Switch Locations: Un-
der front cover close to CDI
box.
2. Disconnect wire harness from switch.
3. Connect an ohmmeter across switch contacts.
Reading should be infinite (∞).
4. Apply brake at handlebar lever and check for
continuity between switch contacts. Replace
switch if there is no continuity or greater than .5
ohms resistance when the brake is applied with
slight pressure.
To Next Page
Loading...
