MAINTENANCE
2.6
MAINTENANCE QUICK REFERENCE CONT’D
7. Tie Rod End
6. Ball Joint
5. Front
Wheel
Bearings
8. Rear Axle Bearings
9. Swing Arm
Bushings
Ill.
#
Item Lube Rec. Method Frequency*
5 Front Wheel Bear-
ings
Sealed; Replace Inspect and replace bearings if necessary Annually ©
6 Ball Joint Polaris All Season
Grease¢
Locate grease fitting on back side of struts and
grease with grease gun.
Semi-annually
¡
7 Tie Rod Ends Polaris All Season
Grease¢
Lift boot. Clean away dirt and grease. Apply fresh
grease by hand and reassemble.
Semi-annually
¡
8 Rear Axle Bearings Polaris All Season
Grease¢
Locate grease fitting on eccentric and grease with
grease gun.
Semi-annually
¡
9 Swing Arm Bus h -
ings
Polaris All Season
Grease¢
Locate grease fitting on swing arm and grease with
grease gun.
Semi-annually
¡
* More often under severe use, such as operated in water or under severe loads.
¡ Semi-annually or 50 hours of operation (refer to Maintenance Schedule for additional information)
© Annually or 100 hours of operation (refer to Maintenance Schedule for additional information)
¢ Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M or
Mobilegrease Special
To Next Page
Loading...
Need help?
General
