8 Operating instructions
Note:
The display disappears about every 40 seconds.
Lightly
press
the
MODE
or shutter button to make it reappear.
3
To darken a picture, press the down (
X
)
control button once to turn on the darken
setting:
4
When you have selected the setting you
want, press the MODE button once to
return to the full display. You can now
retake a picture to make it lighter
(A)
or
darker
(B)
:
To return the camera to fully automatic
operation, press the
A
uto reset button.
Important:
If the
background
of a
flash
picture is too dark but your subject is well
illuminated, the background is too far away.
To correct this problem,
do not
use the
lighten
setting. Instead, press the
A
uto reset
button and retake the picture. Place your
subject
near a background
and remember to
keep both within the 2 to 15 foot flash range.
A
B