Operating instructions 3
e1
Picture counter (counts down to show
how many pictures remain in the film
pack and is used with the sequential pic-
tures and multiple exposures features)
f1
Indicator bar (shows that the feature
above it is on)
g1
A
uto reset button (always returns the
camera to fully automatic operation:
electronic flash, autofocus and audio sig-
nals)
This booklet describes the selection and
use of each special feature individually,
although most of the features may be
used in combination with each other for
creative picture-taking. You can turn the
individual features on or off between
pictures by pressing the
MODE
and
control buttons.
Note:
Closing and reopening the camera
will
always
reset it for fully automatic
operation.
If the display fails to react as expected
when you press the control buttons,
press the
A
uto reset button or close and
reopen the camera to start again.
Operating instructions
Open camera
Place both hands as shown
(h1)
. Slide the
release latch back. The camera will open
automatically.
Load film
Use only Polaroid Spectra film.
Push the film door release button down.
The film door will open.
Hold the film pack by its edges only
(i1)
and slide it all the way into the camera.
As soon as you close the film door, the
battery in the film pack will provide power
to the camera and you will see:
•
the film cover eject
•
the liquid crystal display appear a green
light indicating the flash is ready to fire.
The liquid crystal display should look like
this:
If it does not, press the
A
uto reset button.
Note:
The display disappears about every
40 seconds.
Lightly
press the
MODE
or
shutter button to make it reappear.
To Next Page
Loading...
Need help?
Camera Specifications
Weight and Dimensions
