Features 13
Note: The display disappears about every 40 seconds. Lightly press
the MODE or shutter button to make it reappear.
3 Press the MODE button once to return to
the full display:
4 Press the shutter button and keep it
down to control the time the shutter
stays open. You will know how much
time has elapsed by watching the digital
display. When the time you want has
elapsed, release the shutter button. The
camera will eject the picture.
To return the camera to fully automatic
operation, press the Auto reset button.
Backlighting
The flash must be on when this feature is
used.
Since a backlit subject can appear too
dark in the picture, your camera is
programmed to fire just enough flash to
illuminate the front of your subject. For
best results, your subject should not be
further than 6 feet from the camera.
To use this feature:
1 Press the MODE button until you see only
the backlighting symbol:
2 Press the up (Z) or down (X) control
button once to turn on the feature:
3 Press the MODE button once to return to
the full display. You can now press the
shutter button to take the picture:
To return the camera to fully automatic
operation, press the Auto reset button.