Polaroid XS100i

POLAROID
X
S10
0i USER
GUIDE
where, in
the
event
of
an
accident, you subject yourself
to
bodily contact
with
the camera.
Charging
the
Battery
1.
Connect
the
USB
cable's
mini USB plug
into the camera's mini USB port.
2. Connect
the
cable's
USB plug
into a USB port
of
any computer. Verify that
the
computer
is
on.
3. The Red LED remains on
while
the battery is charging.
4. The Red LED
will turn
off
when
the
battery is
fully
charged.
5. Charge
the
battery before using
the
camera for
the
very first time.
6.
It
takes about 3 hours to
initially
charge the camera. Subsequent charges w
il
l
take 3 hours or less.
Additional Information
When
the
battery
power
is
low,
the
camera will
vibrate three
times
to indicate a
low
battery.
The camera
w i
ll
vibrate
two
seconds to indicate i
t's
out
of
power. If
the
camera is recor
di
ng, it
w
ill
automati
ca
lly
save the
file
and then
shut
down.
DO NOT
attempt
to
remove
the
internal
battery. Doing so
will void the warranty coverage and can
possibly
damage the
camera.
Insert
Micro
SD
Card
The XS100i supports MicroSD cards up to 32GB.
At
the rate
of
4GB per
half-hour,
a 32GB card
w
ill
record
full
high
definition (FHD) video for approximately
4-hours
(1080p@30
fps or 720p@60 fps).
If
there
is
no MicroSD card
in
the
camera,
the
Red
and Green LED
@will flash alternately
and
continuously.
Check that the camera
power
is turned
OFF Insert
a MicroSD card (with the
p
ri
nted
side up) into
the
MicroSD
Card Slot
with
enough finger pressure to keep the edge
of
the
card flush
with
the card slot
opening.
To
remove the Micro-SO card, press the card inward and
release.
Grasp the card w ith
two
fingers and
pull it out.
Never insert a MicroSD card
with
the printed side down. Forcing the card inward in
that
position
will likely
damage
the
card and/or camera.
4
(
I