Polaroid XS100i

POLAROID
XS100i USER GUIDE
3.
To
remove the
Panel Cover,
simply reverse the procedure
in
steps 1 and
2.
*Failure to
properly
seal
your
camera can result in leaks
that
may
damage
or
destroy
your
camera.
Your
warranty does
not
cover
water
damage resulting from
user
neglect.
*The rubber seal on the Panel Cover forms the
waterproof
barrier to
protect
the camera in
wet
and
underwater
conditions.
You
must
keep this seal clean; a single strand
of
hair
or
a single grain
of
sand can cause
water
to leak into the
camera.
*After
every
use in salt water, you
will
need
to rinse the outside
of
the
product
and
the seal
with
non-salt water, then
dry.
Failure to rinse
off
salt
water
can cause corrosion
within
the camera and, in turn, damage
will
result.
Powering
On/Off
To
turn
the
camera
ON:
1.
Press and hold the Power Button
2. The camera will
vibrate, and the Green LED will turn on.
To
turn
the
camera
OFF:
1.
Press and hold the Power Button .
2.
The camera
wi
ll
vibrate
two
seconds, and the Green LED
will
turn off.
Recording
Videos
Before you start recording, select the video resolution by switching the Video Resolution Switch There are
two
HD
options
to
select from: HD
(720p 60fps
or 720p 30fps)
and FHD
(Full
HD
1080p 30fps
or
960p 30fps).
You
can
change the
resolution by changing the settings
with
the
XS100i
software.
There are
two
methods available for starting the video record function. Recording is delayed
1-2
seconds
as
a short
vibration indicates recording has started. The LED indicator illuminates
RED
throughout the recording.
Method
1:
Whether
the camera
power
is
ON
or
OFF,
simply
sl
ide the Recording
Sl
ide Switchfrom
STOP
to
RECto
start
recording.
Method
2:
When
your camera
is
OFF and
the
Recordi
ng
Slide Switch is at the
REC
location, press and hold the Power
Button
to
turn the camera
ON,
and it will start recording.
6