Tight the upper dowel for your safety. The water bottle holder is a Polini
patented product.
9.0- FIRMWARE UPDATE
Internet connection and a cable with micro USB outlet are required to
update the firmware.
Remove the plastic cover, the aluminium cap and connect the cable to the
plug in the right direction.
Updated Firmware are available on www.poliniebike.com
Besides the Firmware it is possible (with the cable connected to the motor)
to download a software to modify the mounting side of the right or left
display and, in case of variation of the tire size, to set the speed detector.
10.0- DISPOSAL
In accordance with the European 2012/19/EU guidelines (waste electrical
appliances) and in accordance with the European 2006/66/EG guidelines
(used or defective batteries), waste materials must be separately collected
and recycled.
Old machines, spare parts or packaging are produced with recyclables
materials. The owner is obliged to dispose them in accordance with the
laws and the environmental impact.
Disposal information for countries outside the European Union
This symbol is valid in the European Union only.
Follow the local regulation for the disposal of used
batteries. In case of doubt, contact the place of
purchase or a bicycles’ dealer.
11.0- PRODUCT REGISTRATION
The registration of the EP-3 + motor must be done through the site www.
poliniebike.com in the “customer assistance” section.
Enter the “motor registration” area and follow the instructions. It is highly
recommended to write the motor serial number which is in the lower side
of the motor case (for the models with skid plate installs, remove it).
To Next Page
Loading...
