POLLOGEN GENEO+ U - OxyGeneo User Application; System Power-Up and Shutdown

11
5. GENEO
+
U ASSEMBLY
6. OXYGENEO USER APPLICATION
POWER UP SEQUENCE AND SYSTEM CHECK
Before turning the geneO+ U on, verify that the power supply
is connected to the system inlet on the back panel and to the
power outlet. The system should only be used with the supplied
power supply.
Switch the ON/OFF control to the ON position on the back panel
(Fig.12).
NOTE: After the ‘geneO+ U by Pollogen’ uploads, the touch
screen will become white and then black with SCREEN TEST
heading as part of the system’s self-system check. Verify that
the screen is in good quality during these rst few seconds of
the system upload.
Following system check, the ‘Pollogen Expect More’ animation
will appear.
Once you have reached the home screen, the system is ready
for use.
TURNING THE GENEO+U OFF
Switch the ON/OFF control at the back of the system (Fig.12).
Remove Power Supply from electrical outlet and disconnect
from the geneO+ U.
Store your geneO+ U and its accessories in a cool, dry place.
(Fig.11)
(Fig.12)
A