65
DETAILED FUNCTION DESCRIPTIONS
Scan & Scan Mode setting (SCAN&SCANS---MENU 1&20)
Functions: under VFO/MR/CH mode, DB-10 allows you to scan the entire current
operating band and memory channels.
Enter Menu 1st and press key to start scanning.
When you have started scanning, press / key to change direction.
It will halt on a signal it encounters, press PTT key to stop scanning; Press MONI
key to stop scanning temporarily.
Press key again to exit the scanning function.
Scanning operation is basically the same in each of the above modes. Before you
begin, take a moment to select the way in which you would like the scanner to
halt on a signal.
Enter Menu 20th to set scan mode. Default: TO.
Three options for the scan mode are available under VFO mode.
TO: in this mode, the scanner will halt on a signal it encounters, and will hold
there for some time. If you do not take action to disable the scanner within
the time period, the scanner will resume even if the stations are still active.
CO: in this mode, the scanner will halt on a signal it encounters, and will hold
there if the stations are still active. And after the carrier has dropped, the
scanner will resume.
SE: in this mode, the scanner will halt on a signal it encounter, it will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
To Next Page
Loading...
