To turn on the headset, slide the Power button.
• Headset volume Fine-tune your headset volume by adjusting the headset's volume up (+) and
down (-) controls.
• Desk phone volume When you are on a call and your voice is too quiet/loud, adjust the speaking
volume on the bottom of the base. If your caller's voice is too loud/quiet on a desk phone call,
adjust the listening
volume.
Make a call (deskphone)
1 Tap the headset call button. The desk phone
icon lights up on your base display. You should
hear a dial tone in your headset.
NOTE Press your phone's Headset button or manually remove the handset if you don't have an
HL10 lifter or EHS cable.
TIP If you do not hear a dial tone, turn over the base and adjust the switch (A--G). "A" works for the
majority of desk phones."D" works for Cisco phones.
2 Dial from your desk phone.
End/take a call
To answer or end a call, tap the headset Call button.
NOTE If you don't have an HL10 lifter or EHS cable, press your phone's Headset button or remove
the handset when answering a call and hang up when ending a call.
Auto answer
Auto Answer automatically answers a call by lifting the headset from the base and ends a call
when replacing the headset in the cradle. Slide the Auto Answer switch to the right to activate.
NOTE Auto answer/end capability requires an EHS cable or HL10 lifter.
Mute a call
Tap the Mute button to mute a call, you hear 3 quick tones. The corresponding base icon turns red.
Tap again to unmute.
Hold a call
To hold an active call, press the Volume Up or Down button for 4 seconds. Press the Call button to
resume a held call.
Switch between calls (flash)
To switch between calls, press the Volume Up or Down button for 4 seconds.
Set up a conference call
You can conference up to 3 additional headsets to a call in progress.
Join Savi headsets automatically (same headset type only)
1 While on a call, place the guest headset into the primary user's charging cradle.
The base subscription LED flashes.
2
The primary user hears a triple tone in their headset indicating a conference request. To accept the
request, press the primary user's headset Call button within 10 seconds.
3
If the process fails or times out because the guest's Call button is not pressed within 10 seconds,
the guest subscription is terminated and the guest hears an error tone.
Join Savi headsets manually
1
While on a call, press the primary user's base subscription button.
The base subscription LED flashes.
System basics
Power on your headset
Adjust volume
Make, answer, end calls
12
To Next Page
Loading...
