1 Turn on your speakerphone and press the Bluetooth button for 2 seconds. You hear "pairing"
and the LEDs pulse white.
2 Activate Bluetooth on your phone and set it to search new devices, select “Poly Sync 20.”
3 Pairing is successful when you hear "pairing successful" and the LED flashes blue.
Connect the USB cable from the USB port on the speakerphone to the USB port on your computer.
Your Bluetooth USB adapter comes pre-paired to your speakerphone.
1 Turn on your speakerphone and insert the Bluetooth USB adapter into your computer.
2 Pairing is successful when you hear "PC connected" and the USB adapter turns solid blue.
NOTE Adapter design may vary.
Pair USB adapter again
Your USB adapter is pre-paired to your speakerphone. In the event that your adapter is
disconnected or bought separately, manually pair the adapter to your headset.
1
Insert the Bluetooth USB adapter into your laptop or computer and wait for your computer to
recognize it.
2
Put your speakerphone in pair mode by sliding the Power switch towards the Bluetooth icon to the
right for 2 seconds. You hear "pairing" and the LED next to the Bluetooth icon flashes red and blue.
3
Put your adapter into pair mode by pressing and holding the recessed pair button with a pen or
paperclip until the adapter flashes red and blue.
Setup
Mobile setup
Corded setup
USB adapter setup
(BT600 models only)
5
To Next Page
Loading...
