POLYCOM REALPRESENCE COLLABORATION SERVER V.8.6 APPLIANCE EDITION INSTALLATION
INSTALLING THE REALPRESENCE COLLABORATION SERVER (RMX) 2000
P
OLYCOM REALPRESENCE COLLABORATION SERVER GETTING STARTED GUIDE 29
1. To install RTM ISDN Card on RealPresence Collaboration Server:
2. On the new RTM ISDN card, move the ejector levers to their fully open
position.
3. Slide in the RTM ISDN card in the RealPresence Collaboration Server
slot.
ADDITIONAL INFORMATION: An RTM ISDN card must connect directly to an MPMRx
card in the opposite-facing front slot.
Figure 1-6: Install RTM ISDN Card on RealPresence Collaboration Server 2000
4. Push the card into the slot until the ejector levers touch the front edge
of the card cage.
5. Push the ejector levers to their fully closed position.
6. Tighten the captive screws on each side of the rear panel of the card,
securing the RTM ISDN card to the RealPresence Collaboration Server.
Mounting the RealPresence Collaboration Server (RMX) 2000/4000 in a
19” Rack
There are two methods for installing the RealPresence Collaboration Server
2000/4000 in a 19” rack:
• Using the rack rail runners on the rack
– Install the telescopic rail runners, as described in Install the Tele-
scopicRailRunnersontheRack.
To Next Page
Loading...
