Polycom soundpoint IP series Quick Start Guide

Polycom SoundPoint/SoundStation/VVX IP
Series
Manual Reconfiguration Procedure
BroadSoft BroadCloud PBX 07/19/2017
For North America
OLDER DEVICES - https://polycom.sipflash.com
For North America
NEWER DEVICES - https://plcm.sipflash.com
For Europe
All DEVICES - https://polycom.broadcloud.eu
For Australia
All DEVICES - https://polycom.broadcloud.com.au
For FED
All DEVICES - https://polycom.broadcloudgov.us
If you are having trouble flashing your device with these URLs, please contact your technical support team
for assistance.
Notes:
●
Use the * key to enter periods (requires a single key press in any key mode)
17. Press the Ok soft key
18. Press Back/Left twice to reach the Save Config screen
19. Press the “Yes” soft key to begin the reboot sequence
Once the boot process has completed, the device will be provisioned for use in the BroadSoft BroadCloud PBX network. If the
station assignment process was properly completed prior to the reboot, the device will boot into a station specific
assigned/usable state. If not, the device will boot into a default unassigned/unusable state, and will remain in this state until
the site administrator has completed the station assignment process. If this occurs, contact your site administrator and
request that station assignment be completed for the device in question.

Polycom soundpoint IP series Specifications

General

Power over Ethernet (PoE)	IEEE 802.3af
Protocol	SIP
Lines	Up to 6 lines (depending on model)
Speakerphone	Full-duplex
Audio Codecs	G.711, G.722, G.729
Power	PoE
Dimensions	Varies by model
Weight	Varies by model
Display	Backlit LCD