To Next PageTo Next PageWhat to do if my Polygroup Water Pump motor fails to start?
If your Polygroup Water Pump motor isn't starting, there are several things to check: * Ensure the GFCI is plugged into a grounded outlet and press the reset button. * Check the circuit breaker on your electrical panel and reset it if needed. If it continues to trip, consult an electrician. * Verify that the line voltage is between 105 and 125 AC volts.
Why is my Polygroup Water Pump filter not cleaning the pool water properly?
If your Polygroup Water Pump filter isn't adequately cleaning the pool, resulting in cloudy or green water, consider these potential causes: * Ensure the chlorine level is within the range of 1.0 - 1.6ppm. * Clean or replace the filter cartridge. * Maintain the pH level between 7.3 - 7.8. * Inspect the filter cartridge for damage, and replace it if necessary. * Check for any obstructions in the strainer basket, filter cartridge, return hose, and return fitting. * Clean the pool and filter more often.
How to fix no flow or low flow in Polygroup SUMMER WAVES SKIMMERPLUS SFX600 return hose?
If you're experiencing no flow or low flow through the return hose of your Polygroup Water Pump, consider the following: * Ensure the water level is between the minimum and maximum limit lines marked on the skimmer canister ring. * Check for any blockages in the strainer basket, filter cartridge, return hose, and return fitting. * Clean or replace the filter cartridge.
General| Model | SUMMER WAVES SKIMMERPLUS SFX600 |
|---|---|
| Category | Water Pump |
| Flow Rate | 600 GPH |
| Voltage | 120V |
| Power Source | Electric |
| Hose Diameter | 1.25 inches |
Provides guidance on supervising children around pools and preventing drowning risks.
Warns about suction fittings, drain covers, and potential entrapment hazards.
Advises on preventing children's access to the pool and securing the area.
Specifies keeping electrical items away from the pool and avoiding certain installation locations.
