SUMMER WAVES
®
CARTRIDGE FILTER PUMP
FOR ABOVE GROUND SWIMMING POOLS
RX-600 / RX-1000 / RX-1500 models
ASME COMPLIANT SUCTION FITTING INFORMATION
9. The suction outlet PSF-100A or PSF-100B is to be replace every 5 years.
10. No tool is required for installation.
11. Service and Winterizing Instructions
CAUTION! DO NOT EXCEED THE MAXIMUM ALLOWABLE FLOW RATE:
1. 45 Gallon per minute (2,700 Gallon per hour).
2. Carefully observe and inspect the suction outlet for damage and tampering before each use of the pool.
3. Missing, broken or cracked suction outlet must be replaced before using the pool.
4. Loose suction fitting should be reattached or replaced before using the pool.
5. Remove and store Suction Outlet assembly if temperatures are expected to fall below 32° F.
1. PSF-100A and PSF-100B Suction Outlets are certified by IAPMO in accordance with the ASME/ANSI A112.19.8b-2009 Suction Fitting for use in Swimming Pools,
Wading Pools, Spas, and Hot Tubs.
2. This is a submerged suction outlet for use with above ground swimming pool.
3. For single drain only. Use only ONE outlet for each pump.
4. Do not locate this suction outlet on sitting areas or on the backrest for such seating area.
5. Install this outlet at location recommended by the pool manufacturer.
6. The maximum allowable flow rate of this suction outlet is 45 gallon per minute (2,700 gallonper hour).
7. Connection Hose:
• Model PSF-100-A is to be connected with 1 1/4” (31.8mm) diameter hose.
• Model PSF-100-B is to be connected with 1 1/2” (38.1mm) diameter hose.
8. The suction outlet is to be mounted at the suction outlet opening as specified by the manufacturer of the above ground pool. The diameter of this opening should be
within the range of 1.77” to 1.85” (45.0mm to 47.0mm). Refer to the following diagram for detail assembly instructions:
PSF-100A AND PSF-100B SUCTION OUTLET
(FOR ABOVE GROUND POOL)
Swimming Pool
Water Hose
Hose Clamp
Lock Nut, To Be Tightened By Hand
Rubber Gasket
Water Cap, To Be Installed
Only During Pump Maintenance
Or Filter Change
Suction Fitting, PSF-100A
Or PSF-100B
Flat Washer
Should you encounter a problem with your Polygroup
®
Product, please do not return the product to the place of purchase. All Warranty claims must be made directly to
Polygroup
®
. Prior to contacting Customer Service, please first review the Troubleshooting Guide in the Installation Manual, or review the FAQ at www.Polygroup.com.
Please review setup instruction videos on www.Polygroup.com/video. If you are still unable to correct the problem, please contact Polygroup
®
Customer Service at (844)
252-9983. Have the product type and your purchase receipt ready. Our Customer Service Representative will assist you in resolving the problem. You may be asked to
return all or part of the product for inspection and/or repair. Do not return any product to Polygroup
®
without a Return Authorization number.
Polygroup
®
Limited (Macao Commercial Offshore), (hereinafter “Polygroup
®
”) warrants to the original purchaser only, the RX type Electric Filter Pump against
defects in material and workmanship for 365 days from the date of purchase. Original Purchaser must retain proof of such purchase in the form of an original store
sales receipt and must produce such upon request by Polygroup
®
or its designated agents. Warranty claims cannot be processed without a valid proof of purchase.
This Limited Warranty applies only to the original purchaser of the product and is limited solely to the repair or replacement of the product, to be decided in
Polygroup
®
’s sole discretion. Consequential damages, including claims for loss of water, pool chemicals, damage, or labor are not covered under this Limited
Warranty.
This Warranty will be declared invalid should the Purchaser modify or repair the product themselves or by unauthorized persons; use non-Polygroup
®
parts or
accessories with the product; use the product in contravention of the manufacturer’s Instructions; use improper voltage; abuse the product in any way; or through
accident or negligence. Normal wear-and-tear is not covered under this Warranty, nor are acts of God outside the control of Polygroup
®
.
IN NO EVENT SHALL Polygroup
®
, THEIR AUTHORIZED AGENTS, RELATED ENTITIES, OR EMPLOYEES BE LIABLE TO THE BUYER OR ANY OTHER
PARTY FOR DIRECT OR CONSEQUENTIAL DAMAGES. Some states or countries, or others jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
LIMITED WARRANTY
DO NOT RETURN PRODUCT TO STORE
For any set up and troubleshooting issues, please visit www.polygroup.zendesk.com.
Customer Service: (844) 252-9983 Email: ctcwarranty@polygroup.com
To order parts and accessories,
please visit www.polygroupstore.com
READ, AND KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
PGIM_CartridgeFilterPumpRX600-1000-1500_CAN_CTC_201611_V01
18
OWNER’S MANUALOWNER’S MANUAL
DISTRIBUTED BY: Polygroup
®
LIMITED (MACAO COMMERCIAL OFFSHORE)
Unit J, 10
th
Floor, Macau Square, Av do Infante D.Henrique, No.43-53A, Macau
Should you encounter any problems, contact Customer Service at (844) 252-9983 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
To Next Page
General
